Strona 1 z 1

Problem z odpaleniem

: wt lut 04, 2020 19:26
autor: tomynek
Witam mam problem z odpaleniem Tourana 1,9 TDI 101km AVQ

Samochód odpala ale po 2 sek. silnik gaśnie

o to błędy :

18049 - Please check DTC Memory of A/C Controller
P1641 - 000 - - Intermittent
Freeze Frame:
RPM: 0 /min
Torque: 2.0 Nm
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 12.31 V
Bin. Bits: 00001000
Temperature: 30.6°C
(no units): 144.0

17058 - Cylinder 4 Glow Plug Circuit (Q13)
P0674 - 000 - Electrical Fault
Freeze Frame:
RPM: 882 /min
Torque: 84.0 Nm
Speed: 0.0 km/h
Load: 5.9 %
Voltage: 14.21 V
Bin. Bits: 00001100
Temperature: 14.4°C
Bin. Bits: 10110000

17978 - Engine Start Blocked by Immobilizer
P1570 - 000 - - MIL ON
Freeze Frame:
RPM: 0 /min
Torque: 0.0 Nm
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 12.16 V
Bin. Bits: 00001000
Bin. Bits: 11100000
(no units): 1.0

17056 - Cylinder 2 Glow Plug Circuit (Q11)
P0672 - 000 - Electrical Fault - Intermittent
Freeze Frame:
RPM: 0 /min
Torque: 178.0 Nm
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 11.86 V
Bin. Bits: 00001000
Temperature: 0.9°C
Bin. Bits: 00110000

18048 - Internal Control Module
P1640 - 000 - EEPROM Error - MIL ON
Freeze Frame:
RPM: 0 /min
Torque: 0.0 Nm
Speed: 0.0 km/h
Bin. Bits: 00000000
Bin. Bits: 00000000
Bin. Bits: 00000000
Bin. Bits: 00000000
Bin. Bits: 00000000


02241 - Engine Control Module; Immobilizer Data not Adapted
000 - -

Re: Problem z odpaleniem

: śr lut 05, 2020 17:54
autor: mammelzen
Ktoś grzebał przy sterowniku i synchronizacja immo nie istnieje. Immo blokuje start